This is page 1-There is a pull out for an extra photo or journaling. For those that are doing the kit, the top Soft Suede smooth sheet goes on the top, the textured piece is on the bottom. The DSP goes in the middle. Hold the two Soft Suede pieces of card stock together and adhere the DSP on top of the Soft Suede. Make sure to center it. Put a rhinestone in the middle of the red star burst if one isn't there for you already. Put a dimensional on the back of each ornament (Delightfully Decorations set). Tape the Gold cord on the top part of the ornament & make sure the Gold cord will fold over the top of the Soft Suede card stock. Adhere the ornament to the DSP where it should be and fold the Gold cord over the top & tape it. Do that with the other two ornaments. Put adhesive on the three sides of the Cobbler card stock, leaving one side open for the vanilla mat to pull in and out. *Make sure that the Soft Suede tab doesn't hang over the DSP. Edge everything with a sponge except the ornaments in Early Espresso or Soft Suede ink. Then spray with the Champagne Shimmer Mist solution.
The next post will contain page 2